 |
Psiber
| LAN/IP Testers
|
|
Psiber Data Systems® Inc., the leader in low cost active
network diagnostic testing, announces the introduction of
the new Pinger Plus+™ Network IP Tester. The Pinger Plus+™
features full 10/100 PING capability as well as 10/100/1000
Link testing. These new features are in addition to the DHCP
Client capability and Port Identification features of the
original Pinger.
|
|
|
 |
Pinger
Network IP Tester 100
The Pinger Plus+ handheld tester is used for installing &
maintaining computer LANs with TCP/IP protocol. It uses the
PING function at either 10/100Mbs to verify connectivity, check
Tx/Rx data integrity, network traffic loading, provide the MAC
address of an IP Address and warns when the default gateway
can not be located. The Pinger Plus+ also identifies reversed
polarity for improperly connected wire pairs and provides a
Port Identification feature with selectable blink rates to identify
which port on a hub or switch that a wall outlet is connected. |
|
|
|
Lan
Master 30
The LanMaster 30 Outlet Identifier provides LAN/Telecom Installers
and Maintainers a tool to quickly test unknown wall outlets
and identities. Some PBX systems can provide voltage and current
levels that far exceed the limits of telecom or network devices
resulting in equipment failure when connected.
The unit 30 scans all combinations of the eight wires connected
to an RJ-45 outlet to identify the type of equipment connected
to the far-end. In less than six seconds, the LanMaster 30 will
identify a 10/100BaseT Link, Token Ring Link, Analogue Telephone,
PBX, ISDN Line or no signal. It indicates when a 10/100 Ethernet
Link is configured for Auto-negotiation. Managing network. |
|
|
|
CableTracker
Network ID Kit
The CableTracker Network Tone and Probe Kit model CTK1015 is
designed for network managers and technicians. Toning an active
LAN circuit can disrupt network traffic and is difficult to
track due to cable twist and tone bleed. The CableTracker Network
Tone and Probe Kit features a Port ID function that blinks the
link light verifying cable connectivity. This feature also provides
a simple and effective method to identify switch or hub port
assignments on active networks. Three different blink rates
are provided to ensure compatibility with equipment from a wide
range of manufacturers. |
|
|
|
Net
1000/1000RS
Psiber Data Systems Inc., the leader in low cost active network
diagnostic testing, announces the introduction of the new Pinger
Plus+™ Network IP Tester. The Pinger Plus+™ features
full 10/100 PING capability as well as 10/100/1000 Link testing.
These new features are in addition to the DHCP Client capability
and Port Identification features of the original Pinger. |
|
|
 |
